Jūsu grozs ir tukšs.

Preces grozā:
0
Kopā:
€0.00

DEV-09947 USB Host Shield SparkFun Ražotājs: Master

Kategorija: /SPARKFUN katalogs/Arduino/Shields

Pilna attēla apskate

Fotogrāfijām ir informatīvs raksturs, kas nevienmēr atspoguļo preces patieso izskatu.

Cena: €33.00
Norādītā cena ir spēkā,
pasūtot preci 07.04.2020.

Cenā iekļauts PVN 21%

Produkta kods: DEV-09947

Garantija: 12 mēn.

 
Ir piegādātāju noliktavā:  X

Skaits:

This new version corrects the pin out for the GPX and RESET pins. The USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!

A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino’s hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.

The Host Shield takes its power from the ‘Vin’ pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

Documents:

Replaces:DEV-09628


Jūsu grozs ir tukšs.

Preces grozā:
0
Kopā:
€0.00

Izvēlēties ražotāju
Kārtot pēc:
Piegādātāju noliktavā

MasterCard SecureCode Learn More
Verified by Visa Learn More




Kurpirkt.lv - visi Latvijas interneta veikali un cenas