Jūsu grozs ir tukšs.

Preces grozā:
0
Kopā:
€0.00

Sparkfun SEN-13637 SparkFun Soil Moisture Sensor (with Screw Terminals) SparkFun Ražotājs: Spalding

Kategorija: /SPARKFUN katalogs/Sensors/Biometrics

Pilna attēla apskate

Fotogrāfijām ir informatīvs raksturs, kas nevienmēr atspoguļo preces patieso izskatu.

Cena: €8.51
Norādītā cena ir spēkā,
pasūtot preci 02.04.2020.

Cenā iekļauts PVN 21%

Produkta kods: SEN-13637

Garantija: 12 mēn.

Ir piegādātāju noliktavā:225+

   

Skaits: Pievienot grozam

The SparkFun Soil Moisture Sensor is a simple breakout for measuring the moisture in soil and similar materials. The soil moisture sensor is pretty straightforward to use. The two large, exposed pads function as probes for the sensor, together acting as a variable resistor. The more water that is in the soil means the better the conductivity between the pads will be, resulting in a lower resistance and a higher SIG out. This version of the Soil Moisture Sensor includes a 3-pin screw pin terminal pre-soldered to the board for easy wiring and setup.

To get the SparkFun Soil Moisture Sensor functioning, all you will need is to connect the VCC and GND pins to your Arduino-based device (or compatible development board). You will receive a SIG out, which will depend on the amount of water in the soil. One commonly known issue with soil moisture senors is their short lifespan when exposed to a moist environment. To combat this, we’ve had the PCB coated in gold finishing (ENIG, or Electroless Nickel Immersion Gold).

Note: Check the Hookup Guide below for assembly and weatherproofing instructions, as well as a simple example project that you can put together yourself!

Get Started with the Soil Moisture Sensor Guide

Documents:


Jūsu grozs ir tukšs.

Preces grozā:
0
Kopā:
€0.00

Izvēlēties ražotāju
Kārtot pēc:
Piegādātāju noliktavā

MasterCard SecureCode Learn More
Verified by Visa Learn More




Kurpirkt.lv - visi Latvijas interneta veikali un cenas