Jūsu grozs ir tukšs.

Preces grozā:
0
Kopā:
€0.00

BOB-11420 MiniGen - Pro Mini Signal Generator Shield SparkFun Ražotājs: Master

Kategorija: /SPARKFUN katalogs/Sensors/Breakout boards

Pilna attēla apskate

Fotogrāfijām ir informatīvs raksturs, kas nevienmēr atspoguļo preces patieso izskatu.

Cena: €36.68
Norādītā cena ir spēkā,
pasūtot preci 26.01.2020.

Cenā iekļauts PVN 21%

Produkta kods: BOB-11420

Ir piegādātāju noliktavā:51+

   

Skaits: Pievienot grozam

This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

Features:

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

Documents:


Jūsu grozs ir tukšs.

Preces grozā:
0
Kopā:
€0.00

Izvēlēties ražotāju
Kārtot pēc:
Piegādātāju noliktavā

MasterCard SecureCode Learn More
Verified by Visa Learn More




Kurpirkt.lv - visi Latvijas interneta veikali un cenas